Pinecone Table Runner

September 18, 2012/in Katie Brown Projects, Tabletop /by kbw71

MATERIALS

• Green fabric
• Stitch Witchery
• Floral wire
• Green wire edge ribbon
• Pinecones
• Ruler
• Chalk
• Scissors
• Glue gun
• Iron

DIRECTIONS

1. Measure tabletop. Cut fabric 18 inches wide and 3 feet longer than your tabletop.

2. Lay fabric face down.

3. Fold both long sides in one inch. Iron to crease. Insert Stitch Witchery into fold and re-iron the fabric to create seam. It is best to let the Stitch Witchery cool for a few minutes between steps.

4. Fold the cloth in half lengthwise and use a ruler to draw a triangle on the edge of the fabric.

5. Cut triangle and open fabric. Cut a small slit into the point of the triangle and fold exposed edges. Insert Stitch Witchery and iron to create seam.

6. Wrap floral wire around large end of pinecone, leaving a few inches to come out at the top. Attach the pinecone to the end of the runner by gluing the wire to the back of a point of the fabric.

7. Tie a bow around the wire with a decorative ribbon and repeat on remaining points of the runner.

8. Another piece of wire can be used to center the pinecone at the points if necessary.

---

---