- 5x7 inch aluminum flashing
- 2 ribbons
- Scalloped scissors
- Large hole punch or awl
- Permanent marker
With your scallop scissors cut the sheet of flashing in half and trim edges.
Using the awl or hole punch, place a hole about ½ inch in on either side. Just eyeball it to be sure the holes are centred from top to bottom.
Cut your ribbons to 12 inches each. Thread both through the holes, coming in through the back of the name card on both sides. Trim as necessary.
Write your guests' names on each flashing sheet, and slip napkin through.